How to change the keypad rubbers on a VB30 button
In this article we will show you how to change a damaged or broken keypad rubbers. You can place an order for any consumables you need for your Vellux product on support@callvellux.com.
Here is a video overview of how to change the keypad rubbers:
Steps to follow:
For this exercise you will need a star screwdriver.
- Gently push the button out of its holder using a pen or other object.
- Now you need to loosen the three screws using your star shaped screwdriver. Careful not to lose any of your screws.
- Now that the screws are removed, the cover should be loose enough to pull apart.
- Remove the battery.
- Gently take out the PC board, but don't touch the programming switches.
- Now remove the old keypad rubber.
- Make sure that you align the edges when placing the new rubber into the cover.
- Make sure the rubber fits well and then place your PC board back into the cover.
- Also make sure that the holes align with the cover. It should fall into place easily.
- Don't forget to place your battery back and facing the right way.
- Place the back cover on top and then tighten the three screws. Don't over tighten them or else the cover might break.
- When the screws are tightened, place the button back into the stand.
That's it. We're all done.
Related Articles
VB30 Buttons - How to Change the Batteries
Changing the Battery on a VB30 Button Follow the steps in the video below to change the battery on a VB30 button. Watch Video Button Specifications Battery Type Watch Video Button Specifications The information in the video applies to the following ...VB200 Buttons - How to change the battery
Each of your wireless buttons have an A23-type battery inside. The battery should give you approximately 1 year or 2500 button-presses before it needs to be changed. If your system is not working well, the first thing to check is that the button ...How to program the VM400 monitor with its pager.
In this article we will look at programming the VM400 monitor, a pager and a button. Below is a full video guide as well as step-by-step instructions and the product manual attached. <br> Retrieving the Capcode from the monitor Switch ...How to program the Vellux “Next Customer Please” Queuing System
Here is a quick video, showing you how to program/delete a button onto the monitor. For detailed steps, please read the article below the video. 1. Identifying Your Equipment Equipment could vary depending on the type of installation but generally ...Programming the VHP4 Pager
Programming the Pager/Watch: Your Capcode(s): {This code is provided by a Vellux technician - send an email to support@callvellux.com to request your code} TO SET THE CAPCODES: On the front of the pager there are two buttons: MODE and PWR. Take out ...